繁體中文
简体中文
Home
Site Map
Contact Us
About Us
Products
News & Events
Customer Service
Employment
Home
>
Products
>
MCU
>
Human Interface Device
> SPRF2411A
Solutions
.
SPMC02A
.
SPCP18A
.
SPCP25A
.
SPCP826A
.
SPCP26A
.
SPCP800A
.
SPCP02A
.
SPCP07A
.
SPCP868A
.
SPCP18E2A
.
SPCP58A
.
SPRF2400A
.
SPRF2411A
.
SPRF2413A
SPRF2411A
2.4GHZ 32CH 2WAY RF OPTICAL/LASER TILT-WHEEL MOUSE SOC
Mouse Features
Decodes mouse sensor automatically for mouse X-Y direction:
Avagotech - A7530; A7050; A5030; A5090; A3040
Pixart – P3204; P3603.
Displacement tracking speed : 12 ~ 20 inchs/Sec.
Sensor orientation Vertical or Horizontal strap for mouse shape.
Flexible support numbers of buttons:
Left; Middle; Right button for standard and side_up; side_down for extended button.
2 tilt buttons (left / right) decode for horizontal scrolling.
2 customized buttons for Multimedia / Internet hot-keys.
In-use Sensitivity Switching to high and low CPI for 2 segment resolution with LED indicator through “CPI_SW” button and no software driver required.
Resolution CPI-LED blinking indicator
- High (1600 / 1000) CPI = LED blinking 2 seconds with 12Hz
- Low (800 / 500) CPI = LED blinking 2 seconds with 2Hz
Supports mechanical wheel encoding (1:2).
High speed mouse report rate up to 125 report/s.
Supports LOP ALPC system to comply IEC 60825-1 eye safety.
SunplusIT software driver available for Tilt-button enable.
Comments Features
Component Reduction:
- Integrated high efficiency DC/DC converter
- Built-in internal 6MHz oscillator and one output clock to external mouse sensor.
- Built-in EEPROM (128 Bytes) used for Channel; ID and RF test memorizes.
Low Operating Voltage from 1.8V to 4.2V.
2.4GHz RF Features
32 channels hopping with 2 group form 2.405GHz ~ 2.476GHz. (see section 6).
Sensitively up to -93 dBm (@ 250kbps).
Output power up to 0 dBm.
Low-noise amplifier, power amplifier, modern and data slicer/recovery on chip.
High speed RF link data rate Max. 1M bit/s.
24 bits ID number (16777216 combinations): allows the receiver to identify its mouse.
1 connect (bind) button for RF link sync or Auto connect (by AP-Tool active) while Power on (batteries insert).
Power Management Features
Smart power On / Off via BIND button (One-touch) or RF disconnected.
Support 5 stages of operate mode for smart battery power saving
- Active mode: when activity (movement; buttons; scrolling) is detected.
- Idle mode: when inactivity (without movement; buttons; scrolling) within 5 Sec.
- Standby mode: Idle mode occurred after 5 Sec. entrance.
- Wait mode: Standby mode occurred after 60 Sec. entrance.
- Suspend mode: Wait mode occurred after 10 min. entrance.
Package
40Pin QFN 6 X 6 mm package available.
BLOCK DIAGRAM
About Us
|
Products
|
News & Events
|
Customer Service
|
Employment
|
© 2010 Sunplus Innovation Technology Inc. All Rights Reserved. |
Contact Us
|
Site Map
|